Ref. NXT1604
Thank you for choosing and the . By following these simple steps, you will be able to
set up and use your Powerful true-seamless AV processor based on ’s new LiveCore™ plaorm
within minutes. Discover the capabilies and intuive interface while commanding top-notch
presentaons and unleash your creavity for a new experience in show and event management.
• 1 x
• 1 x Power supply cord
• 1 x Ethernet cross cable (for device control)
• 1 x MCO 10 pin connector
• 1 x Web-based Remote Control Soware included and hosted on the device
• 1 x Rack mount kit
• 1 x User manual (PDF version)*
• 1 x Quick start guide*
* User manual and quick start guide are also available on www.analogway.com
The uses standard ethernet LAN
networking. To connect the Web RCS to your new
, you rst need to connect a computer
to the using the Ethernet cable. Then
on your computer open an internet browser which
supports Flash® player.
Into this internet browser, please enter the IP
address of the displaying on the front
panel screen.
The connecon should start.
Oen, computers are set to DHCP client (automac
IP detecon) mode. You may need to change the
IP address conguraon on your computer before
you can connect. These sengs are found in the
properes for your LAN network adaptor, and vary
by operang system.
The default IP address on the is
with a netmask of
Therefore, you can assign your computer a stac
IP address of and a netmask of
and should be able to connect.
If the connecon is not starng, please see:
• Be sure the computer IP address is on the same
network and subnet as the .
• Be sure that no two devices have the same IP
address (prevent IP conicts)
• Check your network cable. You will need a
crossover ethernet cable if you are connecng
directly from the to the computer. If
a hub or switch is involved, use straight ethernet
cables.
• For more informaon, please see the user manual
or contact your local technical support.
Once you have successfully connected, the ash
app will automacally download and launch in your
browser. When the two icons in the boom right
corner of the screen turn green, the Web RCS is
ready to use. If you are having trouble syncronizing,
try clearing the cache and refreshing the page
(ctrl+F5 in most browsers):
- will turn green when connected
- will turn green when the Web RCS has
nished syncronizing.
Mounng using only the front
rack ears is sucient for xed
installaons. Addional support,
such as the rear rack support or
slide rails, is required for mobile
applicaons, and recommended
for all.
Commentaires sur ces manuels