Analog-way MIDRA PLATFORM TPP Current Programmer's Guide Manuel d'utilisateur télécharger pdf (Page 19)

PROGRAMMER'S GUIDE FOR v01.02.11

3.4 TAKE : Transitioning a Preview screen onto a Program screen

3.4.1 usage

The “TAKE” action allows transitioning, for a single screen, the “Preview” content (next state) to the

“Program” (current state) using the current transition.

3.4.2 Midra™ transitions reminder

Picture modifications can be made directly on the program screen (in the “current preset”) or can be

prepared on the preview screen (in the “next preset”) and applied synchronously through the TAKE

command. The device will try to apply all preset changes in one step, using user parameters. Depending on

the complexity of preset changes, it can lack resources and be obliged to use two steps or to sequence the

transition. This status can be read through the TAKEINFO command.

Before launching a TAKE command, the TAKEAVA status shall always be read to wait for the device to

be ready.

3.4.3 detailed commands sequence

 Wait for the TAKE availability :

 Launch the TAKE action : Launch the TAKE by writing the value 1.

Syntax : <scrn>,1GCtak

<scrn> is the RCS² screen number minus 1.

Only value 1 is allowed, machine will immediately acknowledge the command, then will do the

transition and last will answer with the 0 value after the end of the TAKE.

3.4.4 example of TAKE

Picture 12 : example of TAKE

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 27 28

Pas de commentaire

Analog-way MIDRA PLATFORM TPP Current Programmer's Guide Manuel d'utilisateur Page 19