Analog-way Octo-Quattro - OTR401 Manuel d'utilisateur télécharger pdf (Page 20)

OCTO-QUATTRO™

PAGE 20

Chapter 7 : CONTROL SOFTWARE

Your OCTO-QUATTRO

™

is shipped with a Windows 95 or later compatible "OCTO-RANGE REMOTE CONTROL"

software (3.5" disk). This software allows you to control and make all adjustments by a simple mouse click.

NOTE:

Preferably use Windows NT, 2000, or XP for LAN operation.

7-1. CONNECTIONS

c CONNECTING TO THE RS-232 PORT:

- Connect the serial port of your control device to the RS-232 port (DB9 Female connector) of the OCTO-

QUATTRO

™

with a straight cable (DB9 Female / DB9 Male).

- Speed transmission: 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.

- Pin-out:

PIN # FUNCTIONS

2 TRANSMIT DATA (Tx)

3 RECEIVE DATA (Rx)

5 GROUND (Gnd)

d CONNECTING TO THE LAN PORT (optional):

- Connect the LAN port (RJ45 connector) of the OCTO-QUATTRO

™

to your network according to your

installation.

7-2. SOFTWARE INSTALLATION

c Turn your computer ON and wait for Windows to completely start.

d Insert the CD-ROM into your drive: the ANALOG WAY home window will open automatically.

e Select the language of the CD-ROM menus, then click on "Install a Remote Control Software" and select the

name of your device.

IMPORTANT:

If the Autorun is not enabled: From the Windows desktop, open My Computer and select the

CD-ROM drive. Select the Autorun folder, then select the autorun.exe file.

f Follow the Windows installation instructions.

7-3. COMMUNICATION SETUP

c Connect the RS-232 or RJ45 cable between the OCTO-QUATTRO

™

and the control device as indicated in the

section 7-1.

d Then only power ON all of the devices.

e Click on the program files Octo_range in Start>program>ANALOGWAY>Octo-Range to run the software.

f Click on Controls menu and select RS232/LAN setup, then:

• CASE OF RS-232 PORT:

- With the LCD menu of the OCTO-QUATTRO

™

device, verify that the RS-232 port is activate (CONTROL >

RS232/LAN port > RS232).

- With the Controls menu of the software, select RS232/LAN setup, then select the COM port number

corresponding to the connection of the OCTO-QUATTRO

™

device.

DB9 female (Rear panel of the OCTO)

If the communication is

OK, the message

"Device connected" is

displayed as well as the

OCTO model in the

windows title bar.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 62 63

Commentaires sur ces manuels

Pas de commentaire

Analog-way Octo-Quattro - OTR401 Manuel d'utilisateur Page 20

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Analog-way Octo-Quattro - OTR401