Analog-way Graphic Switcher II - GSW2811 Manuel d'utilisateur télécharger pdf (Page 29)

GRAPHIC SWITCHER II™

PAGE 29

Chapter 9 :

CONTROL SOFTWARE

9-1. CONNECTION

• CONNECTING THE RS-232

Connect the serial port of your controlling device to the REMOTE RS-232 connector of the GRAPHIC SWITCHER II

™

with a straight cable (DB9 pins female / DB9 pins male).

• PIN-OUT

PIN # FUNCTION

2 TRANSMIT DATA (Tx)

3 RECEIVE DATA (Rx)

5 GROUND (Gnd)

DB 9 female connector

(Rear panel of the GRAPHIC SWITCHER II

™

)

• SPEED TRANSMISSION : 9600 bauds, 8 data bits, 1 stop bit, no parity bit, no flow control.

9-2. "GRAPHIC SWITCHER II

™

CONTROL PANEL" SOFTWARE

Your GRAPHIC SWITCHER II

™

is shipped with a WINDOWS 95/98/2000/Me/XP compatible "GRAPHIC SWITCHER

™

REMOTE CONTROL" software (3.5" disk). This software allows you to control and make adjustments by a simple

mouse click (output format, image adjustments, etc...).

• SOFTWARE INSTALLATION:

c Turn your computer ON and wait for WINDOWS to completely start.

d Insert the disk into the floppy drive.

e In the WINDOWS START menu, click on RUN.

f Choose the disk drive and click on setup.exe (ex : A:\setup.exe if disk 3.5" is drive A).

g Follow the WINDOWS installation instructions. WINDOWS will create a file C:\Programfiles\ANALOGWAY\

Graphic switcher II remote control.

• STARTING UP:

c Connect the RS-232 cables between the controlling device and the GRAPHIC SWITCHER II

™

as indicated in

section 9-1.

d Then only power ON all of the devices.

e Click on the program files GSW2811 in Start-program-ANALOGWAY-GRAPHIC SWITCHER II to run the

software.

f Click on Control menu and select the Serial port.

The GRAPHIC SWITCHER II

™

is now controllable by the computer.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

Commentaires sur ces manuels

Pas de commentaire

Analog-way Graphic Switcher II - GSW2811 Manuel d'utilisateur Page 29

Commentaires sur ces manuels

Produits connexes et manuels pour Audio Analog-way Graphic Switcher II - GSW2811