Analog-way Graphic Switcher II - GSW2811 Manuel d'utilisateur télécharger pdf (Page 6)

GRAPHIC SWITCHER II™

PAGE 6

Chapter 2 :

INSTALLATION

IMPORTANT: Please read all of the safety instructions (pages 2 to 4) before starting.

• Table top mounting: The GRAPHIC SWITCHER II

™

can be used directly on a table: the unit is equipped with 4 plastic

feet.

• Rack mounting: The GRAPHIC SWITCHER II

™

is compatible with a 19” enclosure. Please follow the instructions

below to install the GRAPHIC SWITCHER II

™

in a 19” rack.

c Place the GRAPHIC SWITCHER II

™

in your rack.

NOTE: Your rack must be equipped with some braces.

d Attach the GRAPHIC SWITCHER II

™

to the rack by using 4 screws in the front panel holes

(screws are not included).

e Connect all of the cables of the GRAPHIC SWITCHER II

™

and attach them to the rack with

some tie wraps.

IMPORTANT: - The openings in the front and in the rear panels are for cooling. Do not cover these

openings.

- Be sure that no weight in excess of 2 kg (4.4 Lbs.) is added onto the GRAPHIC

SWITCHER II

™

- The maximum ambient operating temperature must not exceed 40 °C (104 °F).

- The rack and all mounted equipment in it must be reliably grounded to national and local

electrical codes.

1 2 3 4 5 6 7 8 9 10 11 ... 83 84

Pas de commentaire

Analog-way Graphic Switcher II - GSW2811 Manuel d'utilisateur Page 6