Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Manuel d'utilisateur télécharger pdf (Page 46)

7.3.2 Link secon

Once the source is dened, a summary of your rate sengs will be displayed under the tab STATUS.

Conguring the rate to follow a framelock input will lock the output frame rate to match the

selected source. This is useful to eliminate the “strobing eect” which may be visible as an arfact of the

framelocking process. However, be sure that your framelock reference input is a reliable source, as any

disrupons in the reference signal may cause visible glitches on your output, even if the selected framelock

reference input is not currently being displayed.

The Outputs secon denes if you will be using any of the outputs in Dual Link or 4k modes, or if you will be

reassigning the layer resources of one output to another. To acvate a Dual Link output, drag the adjacent

resources onto output 1 or 3, then check the Dual Link opon box.

Dual-Link resoluons (ie: 2560x1600) are only available on the DVI plug on outputs #1 & #3 as they use

resources from both outputs. You will lose the outputs #2 & #4 by acvang the output #1 or #3 as a Dual-

Link output.

The link secon is where the addive modularity is set. This feature is only available for 4U LiveCore™ units.

The device can be run in Single Device (standalone) or as a pair with another device by linking them. Use

the Guideline buon in the upper right of the page to display a diagram of how to connect the two devices.

Please see chapter: 10. Assembling and devices coupling.





1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 117 118

Pas de commentaire

Analog-way ASCENDER 16 (LIVECORE) - Ref. ASC1602 User Manual Manuel d'utilisateur Page 46