Analog-way LIVECORE PLATFORM TPP Current Programmer's Gu Manuel d'utilisateur télécharger pdf (Page 27)

PROGRAMMER'S GUIDE FOR v02.00.46

3.7 Global TAKE: Transitioning the Preview content to the Program (multiple screens)

3.7.1 Usage

The global “TAKE” action allows transitioning, for multiple screens, the “Preview” content (next state)

to the “Program” (current state) using the current transitions.

3.7.2 Detailed commands sequence

 Define which screens will be affected by the global TAKE action : Include a screen in the global screen

list by writing the value 1 or exclude a screen from the global screen list by writing the value 0. It

should be repeated for each existing screen.

Syntax : <Screen>,<value>SPscl

<Screen> is the destination screen to be included or excluded from future global “TAKE” actions.

<value> can be 0 to exclude that screen from future global “TAKE” actions or 1 to include it.

 Launch the global TAKE action : Launch the global “TAKE” action by writing the value 1. This command

uses the global screen list to determine which screens will be affected.

Syntax : <value>SPtsl

Only value 1 is allowed, machine will immediately acknowledge the

command.

This command automatically waits until the end of operation : the global “TAKE” action is ended when

actions have been successfully completed.

Important : Launching a global “TAKE” does not change the global screen list content.

Important : The global screen list content is automatically modified during a

PESMEM_LOAD_AND_TAKE (PSlot) if enabled by the SP_SET_SCREEN_LIST_ON_PESMEM_LOAD

(SPslu) command.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 43 44

Pas de commentaire

Analog-way LIVECORE PLATFORM TPP Current Programmer's Gu Manuel d'utilisateur Page 27